IKEA ASW0551-24020002A Manual - Página 10

Navegue en línea o descargue pdf Manual para Mobiliario interior IKEA ASW0551-24020002A. IKEA ASW0551-24020002A 12 páginas.

Imprimir página

Trouble shooting guide

NOTE!

Do always disconnect the cable from the wall socket before maintenance!

Symptom

The desk does not run

The desk stops and can only run

in the opposite direction.

The desk will only run

downwards even though the

desk is not overloaded.

The desk does not run with full

stroke length upwards. Always

stops at the same position.

The desk does only run a little

upwards and stops.

Basic Setting:

Push the controller downwards. Run the table to the bottom position and keep the pressure on the

controller for min. 6 seconds after both legs have reached bottom position.

At certain errors types this must be done twice in succession. Now the desk is in initial position.

Check

Is the main connected to the leg?

Are all plugs mounted

correctly between the legs and

power supply? See assembly

instruction.

Are there visual damages on the

cables, controls or the legs?

Is the desk in fully extracted

position?

Is there much load on the desk

compared to when the desk

functioned normally?

Has the correct screws been

used when mounting the frame

to the legs?

Is all connections correct?

Is the desk loaded much?

Try

Try to connect a lamp or similar

to the main supply to check that

the supply voltage is OK.

Check all connections.

Damaged parts must be

exchanged - Contact IKEA

Customer Service.

When the desk has reached its

upper position it can only run

downwards.

Remove some of the load and

try again.

Perform Basic settings.

The system has a new endstop

outwards. Perform Basic settings

to remove this stop.

Check if the screw used have

the correct length (assembly

instruction). If the screw is too

long it can damage the leg.

Check all connections.

Reduce weight load and try

again. A Basic setting might be

needed before the desk will drive

upwards.