Bristan ALP 2HBF C Instrucciones de instalación y manual del usuario - Página 11
Navegue en línea o descargue pdf Instrucciones de instalación y manual del usuario para Productos de fontanería Bristan ALP 2HBF C. Bristan ALP 2HBF C 20 páginas.
Imprimir página
Installation Cont.
Bath Shower Mixer
1. Fit the spout and the side body to the
bath ensuring that the washers are fitted
between the bodies and the fixing surface
to create a water tight seal.
2. Secure the spout to the bath using the
washer and metal backnut. Tighten the
backnut onto the threaded tail. A suitable
spanner may be required to fully tighten
the backnut.
3. Screw the fixing rod into the bottom of
the side body. Slide the 'C' shaped rubber
washer and 'C' shaped metal washer
onto the fixing rod up to the underside of
the bath.
4. To secure the side body in place
tighten the fixing nut onto the fixing rod
until it is fully tightened against the 'C'
shaped metal washer. The fixing nut can
be tighten with a suitable spanner.
5. Fit the diverter to the bath. Unscrew the
diverter knob, remove the shroud by
loosening the grub screw and remove the
locking nut. Push the diverter body up
through the underside of the bath and
screw the locking nut onto the thread.
Tighten the backnut underneath to secure
the diverter body in position. Replace the
shroud, tightening the grub screw and
screw the diverter knob back on.
6. Screw the flexi tails into the bottom of
the side body by hand only (DO NOT
OVERTIGHTEN), hot on the left, cold on
the right when viewed from the front and
connect to the water supplies.
11