AIRFLO POP077 Manual de instrucciones - Página 3

Navegue en línea o descargue pdf Manual de instrucciones para Electrodomésticos de cocina AIRFLO POP077. AIRFLO POP077 4 páginas. Classic popcorn maker

Imprimir página

ASSEMBLING PROCEDURES

Step 1:

Hook the kettle onto the hanger

of the main housing.

Step 3:

Insert the removable tray.

-3-

Step 2:

Insert the internal kettle plug

into the socket on the inner top

of the main housing.

Step 4:

Place the door on hinges.

POPPING INSTRUCTIONS

1. Follow assembly procedure.

2. Make sure the popcorn maker is unplugged before you do any of the

following.

3. Before using the unit, please check carefully to be sure voltage (AC240V

~50Hz) is suitable to your home.

4. Clean the internal surface of the kettle with warm soapy water, rinse well

and dry with clean cloth. Wipe down inner and outer housing with damp

cloth.

5. Main unit has a 2-function switch as follows:

-LIGHT: to turn light on;

-POP: to turn motor & heater on.

6. Insert the internal plug into the socket.

7. Plug the power cord into an electric outlet.

8. Before pouring oil or kernels, lift lid up using the lid tab. Turn both LIGHT &

POP switches to on position. The light, heater and motor will be on. Let

the kettle preheat about 2 to 3 minutes. Turn the POP switch to off position

and add oil (1 tablespoon of vegetable, corn, peanut, or sunflower oil).

Immediately add 1/3 cup of corn kernels (Note: 1/3 measuring cup included)

and close lid to the kettle. Turn POP switch on again, stirrer will begin to

rotate and heater will heat up the kettle. CAUTION: Lid might be hot – it is

recommended to use an oven mitt.

9. Popcorn starts popping out through the lid after about 2 minutes.

10. When unit is finished popping – you will no longer heat the corn popping –

immediately turn the POP switch to the off position and pull down the

handle bar of the kettle to release any remaining popcorn in the popper.

This will also stop the remaining popcorn from cooking any further and

avoid possible burning.

11. Keep POP switch off if the unit is not continuously in use.

12. Remove plug from power supply if the unit is not being used.

13.

Repeat step 8 to 10 for continuous popping.

-4-