Bristan Claret CLR 1HBF C/WHT Instrucciones de instalación y manual de usuario - Página 9
Navegue en línea o descargue pdf Instrucciones de instalación y manual de usuario para Cocina & Accesorios de baño Bristan Claret CLR 1HBF C/WHT. Bristan Claret CLR 1HBF C/WHT 16 páginas.
Imprimir página
Installation Cont.
Wall Mounted Basin Mixer/ Bath Filler
1. Identify all components are present
prior to starting installation using
the diagram overleaf, and be sure to
refer to the dimensions on pages 4
& 5 for minimum and maximum wall
cavity depths.
2. Offer the mixer body (7) up to the
wall and once in the desired position,
mark and drill holes for the fixings
(12)
IMPORTANT: Before drilling into walls,
check that there are no hidden electrical
wires, cables or water supply pipes.
This can be checked with the aid of
an electronic detector. If power tools
are used do not forget to wear eye
protection & unplug equipment after
use.
3. Fit the mixer body (7) to the wall
and connect water supplies using the
nut and olive (13). Any further tiling
required, should be completed at this
stage.
NOTE: The tiles should not restrict
access to the valve in order to allow for
servicing of the product if necessary.
Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.
4. Push concealing plate (8). complete
with seal (9), over the valve body and
push towards the tiled surface.
TIP: Use a thin line of silicone based
sealant around the back edge of the
concealing plate to create a tight water
seal.
5. Push the spout (17) on to the pre-
fitted spout connection kit (14);
ensuring that both O-rings locate
within the spout, and both of the
locking grub screws (15) fit into
place, via the 2 small holes in the
concealing plate (8). Tighten grub
screw on the underside of spout to
secure into place.
6. Turn on the water and fully open
the mixer, allowing it to run for a
few minutes and check all joints and
connections for any leaks
9