Gamma X-Els Manual del usuario - Página 15

Navegue en línea o descargue pdf Manual del usuario para Máquinas de encordar Gamma X-Els. Gamma X-Els 20 páginas.
También para Gamma X-Els: Manual del usuario (20 páginas)

Imprimir página

MAINTENANCE & ADJUSTMENTS

the string, it may be excessively tight and should be adjusted by turning the Adjustment Knob

counter clockwise to open the gap between the jaws.

NOTE: Due to the bearings used in the Clamp Lever the action of the Clamp Lever is

very light making it easy to apply excessive clamping pressure. Clamps that are set

too tight can damage the string as well as the string clamp jaws.

The clamp jaws should be cleaned periodically to be free from dirt, oil, and any string coating

residue to grip properly. Knife sharpening stones are excellent for removing build-up on the

diamond coated surfaces and are available.

Adjusting the String Clamp Jaw

Spacing

The string clamps will need minor adjust-

ments according to what string type, con-

struction, and gauge you are using.

To adjust the gap (clamping pressure)

between the clamp jaws, insert the string

through the racquet as if you were beginning

the main strings. Clamp the strings and pull

Adjustment

tension. If the string slips through the jaws of

Knob

the clamp, tighten the clamp by squeezing the

clamp jaws together by hand while turning the

Adjustment Knob, in the clockwise direction.

If the clamp leaves impressions or damages

Clamp Base Locking Nut Adjustment

In the event the Locking Lever rotation is

insufficient to ensure smooth operation of the

clamp base, very minor adjustments to the

Clamp Base Locking Nut can be made with

the supplied 17mm socket. Tighten or loosen

the locking nut in very small increments to

provide more clamping pressure or running

clearance as needed.

Quick Action Clamp Base Removal

Quick Action clamp bases can be removed

from the turntable for maintenance or clean-

ing by removing clamp stop located at the

end of the slot in the turntable. To remove the

clamp stop, remove the two screws holding

the clamp stop in place from the underside of

the turntable. Lift the clamp stop out of the

slot, slide the clamp base to the end of the

slot and lift it out. Replace the clamp base and

clamp stop in reverse order.