Gamma Cove LED 200 Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Equipos de iluminación Gamma Cove LED 200. Gamma Cove LED 200 12 páginas. Cool white & warm white led par/wash

Imprimir página

DMX Basics

DMX512 stands for digital multiplex 512. This means that 512 channels are controlled

digitally through 1 data cable.

A channel is a set of 255 steps that are assigned to control attributes in each light. This

may be a color like red, green or blue, and intensity, strobe, pan/tilt or other attributes.

Multiple sets of 512 "universes" may be used. Only 1 universe will travel on a DMX cable,

but through networked DMX (Art-Net or sACN E1.31), many universes can travel over a

network.

DMX Wiring

DMX works by connecting 1 or multiple lights to the output of a DMX lighting console or

software with a DMX interface.

DMX lights connect in what is called a "daisy-chain". Your first DMX cable will plug it's

male DMX connector into the female DMX connector on your lighting console. The

remaining female connector will then connect to the DMX input on your first light.

You may then connect your next fixture to the output of your first light, and continue the

chain.

32 Fixture Rule – DMX only allows you to connect up to 32 fixtures in a single daisy

chain for signal strength. Sometimes, depending on the fixtures and cable length, this

number is less (or more).

DMX Cables can be 3-pin or 5-pin. These use the same type of data, and in the 5-pin

only pins 1, 2, and 3 are used. The cable should be a 2 conductor, shielded cable of at

least 110 ohms resistance. Microphone cable is not DMX cable.

Please refer to the diagram below:

COVE LED 200 CW/WW – GAMMA LED Vision

Page 7 of 12