Decibel Eleven Hot Stone SMD Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Pedal de música Decibel Eleven Hot Stone SMD. Decibel Eleven Hot Stone SMD 4 páginas.

Output Configuration

The Hot Stone SMD has 6 isolated outputs. All outputs are standard barrel type connectors wired

"center negative", which means the outside barrel is +V. This is the standard wiring for most

guitar effect pedals. However, there are exceptions. Always check the label on the pedal before

connecting, and use a polarity reversal cable if needed (see DC Cables section).

Outputs 1 and 2 are each configured with separate outlets for 9V and 12V. The 9 & 12V outlets

are both fed from the same transformer winding and can supply a combined maximum output

current of 400mA. They can be used individually or simultaneously as long as the combined

current draw does not exceed 400mA.

Outputs 3 - 6 each provide up to 100mA of current at 9V. These outputs will run just about any

battery operated 9V pedal.

DC Cables

There are three types of DC cables included with the Hot Stone Deluxe:

1) 5.5x2.1mm (BLACK) to 5.5x2.1mm (BLACK): This is the standard cable used by most

pedals (BOSS, Ibanez, DOD, and most 9V pedals).

2) 5.5x2.1mm (BLACK) to 5.5x2.5mm center-positive (BLUE): This cable should be used

with the Line6™ 4button modeling pedals and Eventide™ Factor pedals. These can also be

used for powering some AC powered effects (depending on current draw).

3) 5.5x2.1mm (BLACK) to 3.5mm mini plug (tip positive): Use this to supply tip-positive

voltage to any pedals using 3.5mm mini jacks.

Other types power cables can be purchased including:

 Polarity reversal for pedals requiring 5.5x2.1mm "center-positive" connection.

 Voltage Doubling cable for combining two outputs to create 18V or 24V

 Current Doubling cable for combining two outputs to create double current.

 Various lengths and end types are available for purchase.