decina CONTOUR Manual de instalación y del propietario - Página 5

Navegue en línea o descargue pdf Manual de instalación y del propietario para Bañera de hidromasaje decina CONTOUR. decina CONTOUR 8 páginas.

CONNECTING THE SPA BATH PUMP

Once your Spa Pump is in position it is important to connect the spa pump to its control, which will depend on which pump you have.

SPA BATH PUMPS & CONTROLS - THERE ARE 3 TYPES OF SPA BATH PUMPS & CONTROLS

∙

PUMP WITH AN AIR BUTTON CONTROL - AIR TUBE CONNECTION

When the spa bath is installed with an air button (3 metre flexible air tube is supplied). The air tube is attached to the air

button (and if applicable fed through a wall penetration) and attached to the air switch nipple. Cut off any excess air tube with

a sharp knife and ensure any blockages are cleared in the air tube.

∙

PUMP WITH A SENSOR TOUCH PAD CONTROL - TOUCH PAD CONNECTION

When the connection from the pump to the touch pad is fitted correctly and the power switched 'ON', there will be a green

activation light on the electronic touch pad on the rim of the bath.

Connect the touch pad cable

into the housing, with the

alignment shown.

PUMP WITH A REMOTE SPA KEY PUMP CONTROL - REMOTE WIRELESS CONNECTION

∙

Dolce Vita models are operated with a fully synchronised waterproof remote control, operated by long life batteries.

TESTING THE SPA BATH

1. It is a Decina warranty condition to test your spa bath prior to sheeting & tiling as damage can occur during transit or installation.

2. Before enclosing the bath, ensure that no debris or other material is left in the bath as this could impair the pump.

3. Fill the bath with water at least 50mm above the highest jet, check the pump & all pipe connections for any leaks.

4. Ensure the pump power outlet is switched to the 'ON' position.

5. To check the operation of the pump, air controls & jet flow run the spa for 10-15 minutes.

6. How to start your spa depends on the type of pump you have. Please refer to the Pump & Jet Operating Guide (page 5).

DO NOT LEAVE WATER IN THE BATH OVERNIGHT.

Push the connector into the

housing until it 'clicks' into

the fixed position.

Attach the 3mm flexible

air tube (suplied with pump)

onto the air switch nipple.

DO NOT KINK OR WRAP THE AIR TUBE AROUND

THE PIPEWORK.

Push the protective rubber

cap onto the touch pad cable

over the circular housing.

NEVER RUN YOUR SPA BATH WITHOUT WATER.