Green Brook Orion ODM200 Instrucciones de seguridad importantes - Página 2

Navegue en línea o descargue pdf Instrucciones de seguridad importantes para Sensores de seguridad Green Brook Orion ODM200. Green Brook Orion ODM200 2 páginas. Microwave presence detector - ceiling mounted

2. Re-connect mains supply, allow 30 seconds for the sensor to warm-up, and then perform
a walk-by in front of the sensor; lamp should turn on and stay on for approximately 10
seconds, and will go off if no further movement is detected.
1. Turning Lux control fully clock wise, the sensor will operate in both daylight and darkness.
2. Turning Lux control fully anti-clockwise, the sensor will operate in darkness only.
3. Set control to operate at your required daylight level.
1.
Turning the time control fully anti-clock wise will set the on duration to 10 seconds +/- 3
seconds.
2.
Turning the time control fully clock wise will set the on duration to 12 minutes +/- 2
minutes.
1.
Turning the sens control fully anti-clock wise will set the sensitivity to minimum (approx.
1M detection cone).
2.
Turning the sens control fully clock wise will set the sensitivity to maximum (approx. 8M
detection cone).
Replace the clear cover removed above. Fold the metal springs of the sensor upwards and
insert into the installation hole releasing springs, the springs will hold sensor in position, refer
to Dia:3.
Dia:3
Light not coming on
Check that lamp is good.
Check there is nothing obscuring the microwave sensor.
Intermittent operation
Check there are no curtains that can move in the wind.
Check there are no heating vents nearby.
Rated Voltage:
IP Rating:
Ambient Light:
Time Delay:
Rated Load:
Detection Range:
Detection Distance:
Conforms To:
NOTE:
Product & Packaging Disposal
When disposing of this item and its packaging
please follow local regulations and use an
appropriate waste disposal centre.
See GreenBrook website for further details.
ADJUSTING THE 'LUX' CONTROL
ADJUSTING THE 'TIME ON' CONTROL
ADJUSTING THE 'SENSITIVITY' CONTROL
TROUBLE SHOOTING
TECHNICAL INFORMATION
HF System:
Transmission Power:
Power Consumption:
Installation Height:
Cut Out:
Detection Moving Speed: 0.6 - 1.5m/s
Dimensions:
Total Depth -
Ceiling Protrusion -
PLEASE KEEP THESE INSTRUCTIONS
SAFE FOR FUTURE REFERENCE
WEST ROAD . HARLOW
ESSEX . CM20 2BG . UK
www.greenbrook.co.uk
Step 1
Step 3
230V~50Hz
IP20
<3-2,000 LUX (Adj)
Min 10 sec ± 3 sec
Max 12 min ± 1 min
Max 1200W
Max 300W
/LED
360°
1-8M adjustable
5.8GHz CW radar, ISM band
<0.2mW
0.9W approx
1.5 - 3.5M
65mm
76Ømm
75.4mm
17.2mm
BS EN61058-1
Your GreenBrook Microwave Presence Detector
ODM200 is guaranteed for 1 year
from the date of purchase.
This is in addition to your statutory rights.
Step 2
GUARANTEE