KitchenAid Architect Series II KFGS366VSS Manual de instrucciones de instalación - Página 6

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Placa de cocción KitchenAid Architect Series II KFGS366VSS. KitchenAid Architect Series II KFGS366VSS 20 páginas. 30" (76.2 cm) and 36" (91.4 cm) gas built-in cooktop
También para KitchenAid Architect Series II KFGS366VSS: Dimensiones (1 páginas), Manual de dimensiones (1 páginas)

Imprimir página

WARNING

Excessive Weight Hazard

Use two or more people to move and install cooktop.

Failure to do so can result in back or other injury.

Style 1: Cooktop over undercounter built-in oven

IMPORTANT: Clamping brackets should not be used.

1. Using 2 or more people, place cooktop right side up into the

cutout.

NOTE: Make sure that the front edge of the cooktop is

parallel to the front edge of the countertop. If repositioning is

needed, lift entire cooktop up from cutout to avoid scratching

the countertop.

Style 2: Cooktop over cabinets

1. Determine whether your cabinet construction provides

clearance for installing clamping brackets at cooktop base

ends. This is the recommended location. Clamping brackets

can be installed on the front and back of cooktop base

bottom, if necessary.

A. Attachment screw holes for optional front and back location.

B. Clamping bracket (end locations recommended)

C. Cooktop base bottom

D. Attachment screw

E. Attachment screw location (recommended)

2. The clamping brackets can be installed before or after the

cooktop is placed into the cutout. Complete the following

steps for the option you choose.

Installing Brackets Before Placing Cooktop in Cutout

1. Using 2 or more people, place the cooktop upside down on a

covered surface.

2. Remove the attachment screws for the selected bracket

locations from the bottom of the cooktop base.

INSTALLATION INSTRUCTIONS

Install Cooktop

3. Select bracket mounting holes that will allow the bracket to

extend far enough out from the cooktop for the installation of

2½" (6.4 cm) clamping screws. See "Attach Cooktop to

Countertop" for illustration of clamping screw installation.

A. Edge of cooktop base bottom

B. Clamping bracket

4. Attach brackets to cooktop base bottom with bracket

attachment screws using the bracket mounting holes

selected in Step 2.

5. Rotate brackets so they do not extend beyond edge of

cooktop base.

6. Tighten screws just enough to hold brackets in place when

cooktop is put in cutout.

7. Using 2 or more people, turn the cooktop right side up and

place in cutout.

NOTE: Make sure that the front edge of the cooktop is

parallel to the front edge of the countertop. If repositioning is

needed, lift entire cooktop up from cutout to avoid scratching

the countertop.

8. Loosen the screws and rotate the brackets so that they are

perpendicular to the edge of the cooktop base and extend

beyond its edge. Securely tighten screws.

Installing Brackets After Placing Cooktop in Cutout

1. Using 2 or more people, place cooktop right side up into the

cutout.

NOTE: Make sure that the front edge of the cooktop is

parallel to the front edge of the countertop. If repositioning is

needed, lift entire cooktop up from cutout to avoid scratching

the countertop.

2. Remove the attachment screws for the selected bracket

locations from the bottom of the cooktop base.