KitchenAid Architect Series II KFGS366VSS Manual de instrucciones de instalación - Página 9

Navegue en línea o descargue pdf Manual de instrucciones de instalación para Placa de cocción KitchenAid Architect Series II KFGS366VSS. KitchenAid Architect Series II KFGS366VSS 20 páginas. 30" (76.2 cm) and 36" (91.4 cm) gas built-in cooktop
También para KitchenAid Architect Series II KFGS366VSS: Dimensiones (1 páginas), Manual de dimensiones (1 páginas)

Imprimir página
If the "low" flame needs to be adjusted:
The flame can be adjusted using the adjustment screws
underneath the control knob.
A
A
A. Single valve
B. Dual valve
Adjustment for Single Valve:
1. Set the burner flame to LO.
2. Remove the control knob.
3. Hold knob stem with a pair of pliers. Use a
blade screwdriver to turn the screw located within the shaft of
the control knob stem until the flame is the proper size.
Turn adjustment screw "C" to the right to reduce flame
height, turn adjustment screw to the left to increase flame
height.
A
B
C
A.
" (#0 [2.0 mm]) flat blade screwdriver
(screwdriver shaft must be a minimum of
2" [5.1 cm] long)
B. Control knob stem opening
C. Adjustment screw location
4. Replace the control knob.
5. Test the flame by turning the control from LO to HI, checking
the flame at each setting
Adjustment for Dual Valve:
1. Set the inner crown flame to LO.
A. Inner crown
B. Outer crown
2. Remove the control knob.
3. Remove the black rubber grommet.
B
A
A
" (#0 [2 mm]) flat
A
B
4. Using needle-nose pliers, remove the gray shield inside the
burner valve opening.
A. Control knob
B. Black rubber grommet
C. Gray shield
5. Tighten screw "A" to reduce flame height. Loosen screw to
increase flame height.
A
A. Adjustment screw - inner crown
B. Adjustment screw - outer crown
6. Replace the control knob.
7. Set the outer crown flame to LO.
8. Remove the control knob.
9. Tighten screw "B" to reduce flame height. Loosen screw to
increase flame height.
10. Replace the gray shield. Use a screwdriver to help push the
shield into place.
11. Replace the black rubber grommet.
12. Replace the control knob.
13. Test the flame by turning the control from LO to HI, checking
the flame at each setting.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the Use
and Care Guide or contact the dealer from whom you purchased
your cooktop.
A
B
C
B
9