Major tech MT476 Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Multímetro Major tech MT476. Major tech MT476 16 páginas. 690v voltage tester

4. EXPLANATION OF SYMBOLS

The voltage tester shows the following symbols:

DC voltage

AC voltage

DC voltage negative potential (DC)

Phase display from 100 to 690V - 50/60Hz

when used as a "single-pole" phase tester. Continuity test symbol

Rotating field display clockwise

Rotating field display anticlockwise

Device for work to be performed with voltage present

Battery replacement symbol

The voltage tester is operated with two micro-batteries

(type AAA, in the scope of delivery).

Proceed as follows to insert or change the batteries:

• Loosen the screw on the battery compartment lid

(10) with a suitable screw driver and remove it.

• Insert two batteries (AAA) into the battery compartment.

Observe the polarity information in the battery

compartment. If possible, use alkaline batteries. They guarantee a

longer service life. Then, carefully close and screw down the battery

compartment lid again. The batteries need to be changed if the

"Low Bat

" symbol lights up on the LCD display or when the LCD

display stays dark after contacting both test tips.

The voltage tester will show no reading if the batteries are flat. The

device must not be operated with flat batteries or without batteries.

To prevent damage to the device from leaking batteries, remove the

batteries from the device if you will not be using it for a longer period.

For the same reason, we recommend that you remove flat batteries

immediately.

The voltage tester has a battery-operated measuring point lamp. Press

button (9) to switch this lamp on. The lamp stays on as long as this

button is kept pressed. When the button is released, the lamp goes off.

The lighting button is arranged in such a way that it can also be pressed

during low impedance measurements.