Major tech MTC50 Manual de instrucciones - Página 12

Navegue en línea o descargue pdf Manual de instrucciones para Multímetro Major tech MTC50. Major tech MTC50 14 páginas. 2-in-1 lan tester & multimeter

Imprimir página

RJ45 jack on the master unit marked with a ' 回 ' and

the other end of the cable into the remaining receiving

RJ45 jack.

Slide power switch on. The upper row of LEDs will start

to scan in sequence if the Auto/Manual button is set on

"Auto" mode. The LED for pin 1 will light up if the button

is in "Manual" mode.

Switch back and forth from Auto or Manual scanning

mode by pressing the Auto/Manual button on the side of

the master-testing unit.

Once both ends of the cable are plugged in properly, the

second row of LEDs will illuminate according to the

corresponding LEDs in the top row.

Read the results of the LED display for the pin

configuration status of the tested cable. If you fail to

read the results the first time in Auto mode, you may

wait for the second LED scan, or simply switch to

Manual mode for pin by pin testing. In Manual mode,

pressing the square "Test" button will advance testing to

the next pin.

RJ11 Modular Cable Test

Please follow directions for the UTP/STP Cable Test and

use the operations manual for the correct LED pin out

display

Coaxial Cable Test

Plug the two attached BNC adapter cables on both

RJ45 jacks. Then connect the tested cable to each end

of the BNC adapter cables

For the remaining testing procedures, please refer to

10Base-T Test steps 2 to 5.

Note:

The center pin of BNC should be read on LED 2.