Majorcom: EMAGP16 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Sistema de micrófono Majorcom: EMAGP16. Majorcom: EMAGP16 13 páginas.

Imprimir página

EMAGP16

• P rogram the operation and settings of the paging console unit from

the PAGERS/DUCKERS tab of the ePXN1616 web application (see

ePXN1616 web application manual)

• F or maximum sound quality and minimum background noise, use

a screwdriver to set the ADJ control on the side of the unit to a

high level (increase it by turning clockwise) and the GAIN control

on the rear panel of the ePXN1616 (the one associated with the

PAGER A or B port to which the station is connected) to a low

level. You can start from a state with ADJ to maximum and GAIN

to minimum and adjust them following the above indications

until you get the desired signal levels to broadcast the paging

messages in the destination zones.

The maximum lengths for CAT5 or higher cabling connecting a station to

an ePXN1616 unit depend on the AWG category of the cable used. Exa-

mples:

AWG24 Cable

AWG23 Cable

Max. length 90 me-

Max. length

ters

110 meters

If the cable is too long, the paging station may work properly but noise will be superimposed on

the signal picked up by the microphone. The solution to this possible problem is to supply the

paging station with an external power supply. WP24-PSU model. The digital data exchange

between the ePXN1616 unit and the EMAGPE16paging station, using an external power supply

and good quality CAT5E cable, has been successfully tested with a wiring distance of 600 me-

ters.

Usermanual V1.1

56, chemin

de la Flambère ·

F a x 3 3 ( 0 ) 5 6 1 3 1 8 7 7 3 · [email protected] ·

AWG22 Cable

Max. length

140 meters

31300 Toulouse ·

FRANCE · T é l . 3 3 ( 0 ) 5 6 1 3 1 8 6 8 7

www.majorcom.fr

Installation with PXN88 matrix

1.1.

1.1.1. Installation and wiring

To install an EMAGPE16unit, connected to a PXN88, PXN88SG or PXN1212SG unit,

in CAN bus mode, follow these steps:

• R emove the back cover of the unit by unscrewing the screws that

hold it to the chassis to gain access to the connectors inside:

o RJ45 connector (1): connect a CAT5 or higher cable from

this connector to the REMOTE 1 or REMOTE 2 port of the

PXN88, or to the REMOTE port of PXN88SG or PXN1212SG

matrices. If other EMAGPE16or WPTOUCH digital devices

must be connected to the same port, in daisy chain topo-

logy, the included RJ45 to screw terminals adapter can be

used.

REMOTE ports in the back panel of PXN matrices