Century CJW2500X SERIES Manual del usuario - Página 8

Navegue en línea o descargue pdf Manual del usuario para Estufa de leña Century CJW2500X SERIES. Century CJW2500X SERIES 20 páginas. Epa approved high efficiency air tight insert

Imprimir página

CONTACT YOUR LOCAL BUILDING AUTHORITY FOR APPROVED METHODS OF

INSTALLATION

WARNING: This fireplace insert must be connected to: A chimney complying with the

requirements for type HT chimneys in the Standard for Chimneys, Factory-

A code-approved masonry chimney with chimney liner.

a) This insert must be connected to a code-approved masonry chimney or listed factory-built

fireplace chimney. When installation is to a factory-built fireplace chimney, a direct flue

connection will be required. Contact the chimney manufacturer or local building authorities

for approved method. When installation is into a masonry chimney, a chimney connector of

a minimum 24 gauge steel must be installed into the first chimney liner section. The cross

sectional area of either type of chimney must not be less than the inside cross sectional

area of the flue collar, nor shall it be greater than 85 square inches (550 cm ). The

chimney connector must be secured with a minimum 3 screws at the flue collar and each

adjoining sections.

b) A chimney connector shall not pass through an attic, roof space, closet, floor, ceiling or

similar concealed space. Where passage through a wall or partition of combustible

construction is desired, check with local building officials for requirements in your area.

c) It is advisable to have your masonry chimney inspected for deterioration such as cracks

and crumbling mortar before you install your unit.

d) To help ensure a good draft, the top of the chimney should be at least 3 feet (914mm)

above the point of penetration through the roof, and be at least 2 (610mm) feet higher than

any point of the roof within 10 feet (3048mm).

e) Do not use makeshift compromises during installation.

f ) Do not remove bricks or mortar from the fireplace.

The smoke chamber

must be sealed

using

noncombustible

material, to prevent

smoke from re-

entering the room.

The installation shall

be such that the

chimney system can

be inspected and

cleaned.

ALTERNATE CHIMNEY INSTALLATION

WHICH APPLIES TO THE USA ONLY

built, Residential Type and building Heating Appliance, Ul103,

Chimney liner

The cross sectional area must

not exceed 85 square inches

(550 cm )

Chimney connector into the first

section of the flue liner.

Masonry fireplace

Drill flue collar to permanently fasten

chimney connector. A minimum of 3

screws will be required.

Insert.