ENGLISH
Problem
The lamp does not work.
The lamp does not work.
The compressor operates
continually.
The compressor operates
continually.
The compressor operates
continually.
The compressor operates
continually.
There is too much frost and
ice.
There is too much frost and
ice.
There is too much frost and
ice.
There is too much frost and
ice.
Water flows on the rear
plate of the refrigerator.
Water flows inside the re-
frigerator.
Water flows inside the re-
frigerator.
The temperature in the ap-
pliance is too low/too high.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The lamp is in stand-by
mode.
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
inserted at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly or the gasket is de-
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor-
rectly.
During the automatic de-
frosting process, frost melts
on the rear plate.
The water outlet is clog-
ged.
Food products prevent
water from flowing into the
water collector.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
Solution
Close and open the door.
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait a few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products bet-
ter.
Refer to "Operation" chapter.
This is correct.
Clean the water outlet.
Make sure that food products
do not touch the rear plate.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
16
Imprimir página