Century ES-8500 Manual del usuario - Página 8
Navegue en línea o descargue pdf Manual del usuario para Cargador de batería Century ES-8500. Century ES-8500 8 páginas. Portable power source
Imprimir página_estion:
Answer:
Question:
Answer:
Question:
Answer:
Question:
Answer:
in the development and
designing of the portable
power source. Most
battery outlets can dispose
of this product at its life's
end.
!H IMPORTANT
!!!
BA'I-rERY
REMOVAL
AND
DISPOSAL
What is the ideal in-use
IPhl
storage temperature
of the
portable
power source?
Room temperature. The
portable power source will
also operate at below zero
temperatures, however its
power will be less. Intense
heat will accelerate self
discharge.
I have a regular 10 amp
battery charger, can I use
it to recharge the portable
power source?
No, only the wall charger
supplied with the Portable
Power Source should be
used. A higher amp
charger may damage the
batteries.
Is the portable power
source goof proof?
No. Jump starting
instructions must be
followed.
See back of
portable power source.
I'm recharging my portable
power source, should the
charged light immediately
come on?
No. The charged light will
only come on once the
Booster pac approaches
full charge. However, the
charging light (first one on
left) should come
indicating that charging is
taking place.
Contains
sealed,
non-spillable
lead
acid battery.
Must
be disposed
of properly.
The battery inside this portable power
source is a sealed lead-acid battery.
By
LAW, it is required to be removed and
recycled or disposed of properly.
While
there are federal regulations that must be
followed throughout the United States,
your individual state or local governments
may have additional regulations to be
followed in your area.
When the battery in this product is in need
of replacement, remove it according to
the instructions provided below and take
it to your local recycling center for proper
recycling or disposal.
If you don't have a
local recycling center that handles sealed
lead-acid batteries, contact your local
environmental
agency for instructions.
Battery Removal Instructions
Begin by making sure that both booster
clamps are securely stowed in their
holsters on each side of the portable
power source.
1. Remove all 13 screws (4 on the left
side, 4 on the right side, 4 on the
bottom, and 1 under the front label
near the top). Then lift off the back
cover.
2.
3.
4.
Remove the cables from the battery
or batteries.
Lift the battery out of the front half of
the enclosure.
To install a new battery, reverse the
above procedure.
Note:
Remember that the red wires
connect to the positive (+) battery
terminal and the black wires
connect to the negative (-) battery
terminal.