IKEA DATID Instrucciones de instalación y manual de uso y mantenimiento - Página 12
Navegue en línea o descargue pdf Instrucciones de instalación y manual de uso y mantenimiento para Placa IKEA DATID. IKEA DATID 18 páginas. 30" (76.2 cm) wall-mount canopy range hood
También para IKEA DATID: Manual del usuario (16 páginas), Manual de instalación (12 páginas), Manual (24 páginas)
Imprimir página
- 1. Range Hood
- 2. Range Hood Safety
- 3. Important Safety Instructions
- 4. Read and Save These Instructions
- 5. Tools and Parts
- 6. Venting Requirements
- 7. Electrical Requirements
- 8. Installation Instructions
- 9. Install Range Hood
- 10. Make Electrical Connection
- 11. Complete Installation
- 12. Range Hood Care
- 13. Wiring Diagram
- 14. Assistance or Service
- 15. Instructions D'installation
IMPORTANT: Clean the hood and grease filters frequently
according to the following instructions. Replace grease filters
before operating hood.
Exterior Surfaces:
To avoid damage to the exterior surface, do not use steel wool
or soap-filled scouring pads.
Always wipe dry to avoid water marks.
Cleaning Method:
■ L iquid detergent soap and water or all-purpose cleanser
■ W ipe with damp soft cloth or nonabrasive sponge, and then
rinse with clean water and wipe dry.
Metal Grease Filter:
1. Remove each filter by pulling the spring release handle, and
then pulling down the filter.
A
A. Spring release handle
2. Wash metal filters as needed in dishwasher or hot
detergent solution.
3. Reinstall the filter by making sure the spring release handles
are toward the front. Insert aluminum filter into upper track.
4. Push in spring release handle.
5. Push up on metal filter and release handle to latch
into place.
6. Repeat steps 1-5 for the other filter.
Non-Vented (recirculating) Installation Filters:
The charcoal filter is not washable. It should last up to 6 months
with normal use. Replace with Charcoal Filter Kit. See the
"Assistance or Service" section for information on ordering.
To replace charcoal filter:
1. Remove metal grease filter from range hood. See "Metal
Grease Filter" in this section.
2. Bend spring clips away from metal grease filter.
12
RANGE HOOD CARE
Cleaning
3. Place charcoal filter into top side of metal filter.
4. Bend spring clips back into place to secure the charcoal
5. Replace metal grease filter. See "Metal Grease Filter"
Turn off the range hood and allow the halogen lamp to cool. To
avoid damage or decreasing the life of the new lamp, do not
touch lamp with bare fingers. Replace lamp, using tissue or
wearing cotton gloves to handle lamp.
If new lights do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect power.
2. Use a flat-blade screwdriver and gently pry the light cover
3. Remove the lamp and replace with a 120-volt, 40-watt
4. Replace the light cover.
5. Reconnect power.
filter to the metal filter.
in this section.
Replacing a Halogen Lamp
loose.
maximum, halogen lamp made for a G-9 base.