IKEA DATID HGA4K Manual - Página 9

Navegue en línea o descargue pdf Manual para Placa IKEA DATID HGA4K. IKEA DATID HGA4K 24 páginas. Lagan
También para IKEA DATID HGA4K: Instrucciones (4 páginas), Manual del usuario (16 páginas), Manual de instrucciones de montaje (20 páginas), Manual (12 páginas)

Imprimir página

ENGLISH

What to do if ...

Service instructions

Service and maintenance is only to be

carried out by an authorised person.

To replace parts such as burners, valve

and electric components, the hotplate

must be removed from the bench top by

releasing the attachment hooks, loosening

the attachment screws of each burner,

unscrewing the hotplate attachments nuts

which are visible at the bottom of the

Problem

The electric ignition

does not work

The burner fails to ignite

The gas ring burns

unevenly or flame is not

even.

Possible cause

There is no electrical supply

The gas tap could be closed

- Not pressing down the

ignition knob long enough

- Gas cylinder (liquid gas) is

empty

- Burner openings clogged or

dirty

- Burner parts not positioning

correctly.

- Draughts near the hob

- Minimum gas setting and

injector sizing is incorrect

surface, removing the hotplate top, taking

care to remove lid taps and screws under

them and finally replacing the defective

parts.

Note: If the valves must be replaced, first

disassemble the chain of ignition switches.

It is recommended to replace the valve

gaskets each time the valve is replaced, thus

ensuring a perfect seal between the body

and the gas train.

Solution

Check the unit is plugged in

and the electrical supply is

switched on.

Check that the gas tap is

open

- When lighting the burner,

the knob has been pressed

down for enough time to

allow activating the protection

device.

-Check that the gas or

electrical supplies are not shut

off and especially that the gas

supply tap is open.

- Check that the gas cylinder

(liquid gas) is not empty.

Replace is empty.

- Clean the burner openings

and plug end

- Check all burner parts have

been positioned correctly.

- Check there are no

draughts near the hob.

- Check minimum gas setting

& injector (see relevant

paragraphs)