Airflow Uno hab Manual de instrucciones de instalación y funcionamiento - Página 11

Navegue en línea o descargue pdf Manual de instrucciones de instalación y funcionamiento para Controlador Airflow Uno hab. Airflow Uno hab 16 páginas. Cavity wall decentralised mechanical ventilation with heat recovery unit
También para Airflow Uno hab: Instrucciones (2 páginas), Kit de instalación (16 páginas), Manual de mantenimiento (2 páginas)

Imprimir página
m
WARNING
m
CAUTION
© Airflow - we reserve the right to make changes without prior notice
6.2

Cleaning the heat accumulator and protection guard

m WARNING!
The unit must be isolated from the mains power supply before any maintenance and installation work or
before opening the terminal compartment!
The Unohab heat accumulator consists of an easy-to-clean ceramic stone. The ceramic heat accumulator can be
rinsed with water as part of the regular overall maintenance of the ventilation unit. Proceed as follows:
1. Remove entire inner panel from the wall or from the wall installation sleeve (fig.17).
2. Remove the 2-part connector (fig.18) and detach.
Remove
inner panel
3. Pull the fan unit from the wall installation sleeve using the pull-out tool (fig.19).
4. Remove lip seals (fig.20).
5. Remove the top EPP half shell labelled "TOP" (fig.20).
Fan unit
6. Remove ceramic heat accumulator from the EPP-half-shell (fig.21) for cleaning.
m
CAUTION!
Carefully remove the foam sealing tape (fig.21) before cleaning!
– rinse under warm water
Ceramic heat
accumulator
Protection
guard
Unohab Unit
fig.17
fig.19
Pull-out tool
11
Installation and Operating Instructions
Remove
connector
Connection cable not pictured!
"TOP"
Lip seal
Foam sealing tape
mRemove before cleaning!
Protection
guard
fig.18
fig.20
fig.21