IKEA FORDELAKTIG Manual - Página 26
Navegue en línea o descargue pdf Manual para Placa IKEA FORDELAKTIG. IKEA FORDELAKTIG 32 páginas.
También para IKEA FORDELAKTIG: Manual (32 páginas)
Imprimir página
ENGLISH
Troubleshooting
Error code
"Acoustic signal
upon ignition. No
error code dis-
played"
ER03
ER21
E2
E3
E6
E8
E4 / E5 / E7 / E9 /
ER20 / ER22 / ER31 /
ER36 / ER42 / ER47 /
EA / EH
If there is a fault try to solve the problem
by following the troubleshooting guidelines.
If the problem cannot be solved contact the
After-Sales Service. You can find a full list of
IKEA appointed contacts at the end of this
user manual.
Description
Possible causes of the error
The hood com-
LIN cable damaged or badly con-
mand does not
nected to the hood electronic
work
board
Continuous key activation detec-
ted.
Hob switches off
after 10 sec.
Water or pan placed on the con-
trol panel.
The internal temperature of elec-
Hob switches off.
tronic parts is too high.
Empty or unsuitable pan.
Corresponding
Pan or ceramic glass surface
cooking area
temperature too high.
switches off.
Electronic component temperat-
ure too high.
Unsuitable pan.
Corresponding
The pan is losing its magnetic
cooking area
properties and may damage the
switches off.
induction hob.
Hob does not
Power supply voltage and/or fre-
switch on.
quency is out of range.
Fan fault.
Cooking areas
are turned off.
Fan blocked by dust or fibres.
Disconnect the hob from the power supply.
Wait a few seconds, then reconnect the hob to the power supply.
If the problem persists, call the After Sales Service and specify the error code that appears on the dis-
play.
Fan not working
Hood not working
Solution
Check the connection. If the error persists, con-
tact the After-Sales Service.
Remove water or pan from the ceramic glass
surface and control panel.
Let the hob cool down.
Please check if the hob has sufficient ventilation.
If the error persists, please contact the After-Sales
Service.
Let the hob cool down.
Use a suitable pan.
Do not heat empty pans.
Use a suitable pan.
The error is automatically cancelled after 8
seconds and the cooking area can be used
again.
If any other errors occur, the pan must be
changed.
If the error persists, please contact the After-Sales
Service.
Check mains voltage and/or frequency.
If necessary, contact the After-Sales Service.
Clean and remove foreign bodies from the fan.
If the error persists, please contact the After-Sales
Service.
Cable fan unplugged
Hood power cable disconnected
If you operate the appliance incorrectly,
or the installation was not carried out by an
authorised installer, the visit from the After-
Sales Service technician or dealer will not be
free of charge, even during the warranty
period.
Plug the cable
Reconnect the hood power cable
found towards the front right un-
derneath the hob.
26