Gantner GAT Access 6600 B Manual de inicio rápido - Página 4

Navegue en línea o descargue pdf Manual de inicio rápido para Controladores de acceso IP Gantner GAT Access 6600 B. Gantner GAT Access 6600 B 4 páginas. Access control terminal with rfid and barcode

Imprimir página

Electrical connections

TCP/IP with external power supply

TCP/IP

Network

Ethernet (default) or RS 485 bus connection.

Attention: Both interfaces must not be operated at the same time!

Only connect the A and B signal lines when using RS 485 bus connection.

Do not use the COM terminal.

RS 232/USB

to PC/Server

Power supply

DC power supply that complies with SELV (safety extra low voltage) and

LPS (limited power source). See technical data for details. GANTNER

offers the GAT NET.Power Supply 100-240V to supply the GAT Access

6600. When using the GAT NET.Power Supply 100-240V the provided

power plug must be cut off and the cabling terminated onto the "VIN +"

and "GND" screw terminals (see details in diagram above).

The two "VIN +" terminals are internally directly connected. The voltage

input is protected against reverse polarity.

Recommended cables

Ethernet: min. CAT 5 (STP) for 100 MBit

RS 485: min. CAT 5 (STP), power supply via 2 wire pairs

Valid as from June 16

2015 • Technical data subject to modifications without notice!

DB_GAT-ACCESS6600--EN_11.indd • PartNo.: 822630

Motor

Peripheral

Antenna 2

Key 1

Internal electronics

Motor

Peripheral

Antenna 2

Mains power

Interface converter

ISK 200

GAT Access 6600

MOLEX-Cut-off power plug

VIN+ ... black + white line

GND ... black

Key 2

Key 3

Key 4

Mains power

Power supply unit

GAT NET.Power Supply 100-240V

Relay outputs

For activation of devices such as turnstiles, etc., each relay provides

NC (normally closed) and NO (normally open) operation. The permitted

switching power levels (see technical data) must never be exceeded.

Optocoupler inputs

Potential free inputs for status detection. An input voltage must be applied

to activate the input. This voltage can be supplied by the terminal's power

source or from an external power source. Please observe the maximum

permitted input voltage and current (see technical data).

Safety instructions

- This device must be installed by qualified personnel only.

- The applicable safety and accident prevention regulations

must be observed.

- Safety devices must not be removed.

- Please observe the technical data of the device specified

on the data sheet.

- The device must be disconnected from the power supply

prior to installation, assembly or dismantling.

e.g. Turnstile

Motor control

Feedback contact