Gantner GAT NET.Lock 7000 Manual - Página 6

Navegue en línea o descargue pdf Manual para Mobiliario interior Gantner GAT NET.Lock 7000. Gantner GAT NET.Lock 7000 6 páginas. Electronic locker locks

Imprimir página

Electrical Connection

GAT NET.Lock 7000 Back Side
Connection Cable
To connect the GAT NET.Lock 7000 to a GAT NET.Controller S 7000
use the GAT NET.Lock Cable with 4-pin MOLEX plug on both ends. It is
possible to connect 2 of these cables by using a GAT NET.Lock Connector
(see order information).
To connect a GAT NET.Lock 7000 only an original cable from
GANTNER Electronic GmbH may be used.
Power Supply and Signal Lines
DC power supply (see technical data) for unlocking and for the RFID
reading field.
Antenna Adjustment
The GAT NET.Lock 7000 can automatically adjust the RFID antenna. A
description can be found in the manual of the GAT NET.Lock 7000.
Valid as from September 27
6
DB_GAT-NET-Lock7000--EN_20.indd • Art.Nr.: 573734
1
1
1
1
2013 • Technical data subject to modifications without notice!
th
1
Cable Outlets
Cut-out one of these outlets (1) in order to feed the cable out of the
housing.
Configuration
The configuration of the GAT NET.Lock 7000 and the controllers, where
the GAT NET.Lock 7000 is connected, is done via the GAT Relaxx PC
software. The configuration is described in the GAT NET.Lock 7000 and
the GAT Relaxx manuals.
Safety instructions
- This device must be installed by qualified personnel only.
- The applicable safety and accident prevention regulations
must be observed.
- Safety devices must not be removed.
- Please observe the technical data of the device specified
on the data sheet.
- The device must be disconnected from the power supply
prior to installation, assembly or dismantling.
www.gantner.com