IKEA SMAKLIG Manual - Página 31

Navegue en línea o descargue pdf Manual para Placa IKEA SMAKLIG. IKEA SMAKLIG 48 páginas.
También para IKEA SMAKLIG: Manual (24 páginas), Manual (24 páginas), Manual (24 páginas), Manual de instrucciones de instalación (36 páginas), Manual (44 páginas), Manual del usuario (16 páginas), Manual (28 páginas)

Imprimir página

ENGLISH

590 mm

±1

490

55 mm

max.

R 5 mm

min. 38 mm

5 mm

Important!

• For further information on the installation

refer to the Assembly Instruction.

• If there is no oven beneath the hob insert

a dividing panel at a minimum distance of

20 mm from the bottom of the hob.

Electrical connection

Warning! Refer to Safety

chapters.

Warning! All electrical

connections must be made by an

authorised installer.

Electrical connection

• Before connecting, check that the

nominal voltage of the appliance, stated

on the rating plate, corresponds to the

available supply voltage. Also, check the

power rating of the appliance and ensure

that the wire is suitably sized to suit the

appliance power rating (refer to the

"Technical data" chapter). The rating plate

is located on the lower casing of the hob.

• The appliance is not provided with a

mains cable. Buy the right one from a

specialised dealer. Single phase or two-

min. 500 mm

520 mm

±1

560

min.

100 mm

• Do not use silicon sealant between the

appliance and the worktop.

phase connection requires a mains cable

of minimum 70°C temperature stability.

Cable needs mandatory end sleeves.

According to IEC regulations use for one-

phase connection: mains cable 3 x 4mm²

and for two-phase connection: mains

cable 4 x 2.5mm². Please respect in first

priority specific national regulations.

• The appliance works perfectly on AC 230

V, AC 220 V~ or AC 240 V~ 50 Hz electrical

network.

• You must have the means for

disconnection incorporated in the fixed

wiring. Have the appliance connected to

the mains using a device that allows the

appliance to be disconnected from the

mains at all poles with a contact opening

width of at least 3 mm, eg. automatic line

protecting cut-out, earth leakage trips or

fuse.

min.

38 mm

min. 5 mm