CEP 6502GTL: 6503GU Instrucciones de instalación y funcionamiento

Navegue en línea o descargue pdf Instrucciones de instalación y funcionamiento para Unidad de distribución de energía CEP 6502GTL: 6503GU. CEP 6502GTL: 6503GU 3 páginas. Temporary branch power distribution unit with ground fault protection for personnel

Imprimir página

CEP 6502GU/GTL, 6503GU/GTL

SPECIFICATION

These installation and operation instructions

apply to the following temporary power

branch distribution system components. Do

not discard these instructions, save for future

Reference.

PORATBLE POWER

DISTRIBUTION UNITS

These units are rated 20, 30, or 50 amps,

125/250 VAC, Single Phase. The max. ampacity

for these units is 40A @ 120V. The 20 amp, 120

volt outlets are individually protected by circuit

breakers and GFCI circuit modules.

Model

Number(s)

6502GU,6503GU

99577,99577C

6502GTL, 6503GTL

INTRODUCTION

CEP temporary power distribution units equipped

with GFCI modules that will protect you from

electrocution hazards resulting from ground

faults. Ground faults are current leaks and can

result in electric shock. Currents of only 60/1000

of an ampere can be fatal. The GFCI protection

provided by CEP temporary power distribution

units significantly minimizes shock hazards. CEP

temporary power distribution units,

99577, 99577C

Temporary branch power distribution unit

with Ground Fault Protection for personnel

Installation and Operating Instructions

20 Amp

Receptacle

U-Ground

Twist Lock

which are UL listed as Class A, Group I

interrupters, respond to fault currents as low as

3-6 milliamperes, and will shut of the current

within 1/40

of a second. The temporary power

distribution unit is designed to provide protection

against electrical shock hazards due to line-to-

ground faults. Although the GFCI module does

not eliminate the hazard of a shock, it does limit

the duration of the shock to a period considered

safe for normally healthy persons.

GFCI modules will provide protection against

ground faults only. They will not protect against

overloads or short circuits. There is no known

device that will guard against the electrical shock

hazard resulting from contact with both the "hot"

and neutral wires of the electrical circuit.

ELECTRICITY IS DANGEROUS.

EVEN WHEN SAFETY DEVICES ARE

PRESENT, HANDLE WITH CARE AND USE

REASONABLE CAUTION.

LET CAUTION PREVAIL

The CEP temporary power distribution unit is

designed to be used on a grounded electrical

supply system. It will not operate when supplied

from a power source which is not grounded.

Over-current protection of the proper rating,

according to the National Electric Code, Article

240, must be used on the supply circuit feeding

the temporary power distribution units.