HIKVISION Turbo HD DS-2CE76H8T-ITMF Manual del usuario - Página 7
Navegue en línea o descargue pdf Manual del usuario para Cámara de seguridad HIKVISION Turbo HD DS-2CE76H8T-ITMF. HIKVISION Turbo HD DS-2CE76H8T-ITMF 17 páginas. Turret & dome camera
Imprimir página
8. Connect the corresponding cables, such as power
cord, and video cable.
9. Power on the camera to check whether the image on
the monitor is gotten from the optimum angle. If not,
adjust the camera according to the figure below to get
an optimum angle.
1). Hold the camera body and rotate the enclosure to
adjust the pan position [0° to 360°].
2). Move the camera body up and down to adjust the
tilt position [0° to 75°].
3). Rotate the camera body to adjust the rotation
position [0° to 360°].
2.2 Installation of Type II Camera
Before you start:
Both wall mounting and ceiling mounting are suitable for
the turret camera. Ceiling mounting will be taken as an
example in this section. You can take steps of ceiling
mounting as the reference, when adopting the wall
mounting.
Steps:
1. Disassemble the turret camera by losing the screw.
2. Remove the mounting base from the camera body.
3. Paste the drill template (supplied) to the place where
you want to install the camera.
4. Drill the screw holes according to the drill template,
and the cable hole (optional) on the ceiling.
Note:
Drill the cable hole in the center of the drill template,
when adopting the ceiling outlet to route the cable.
5. Secure the mounting base to the ceiling with the
supplied screws.
Figure 2-5 3-axis Adjustment
Figure 2-6 Disassemble the Camera
Figure 2-7 Drill Template