Decor Star WPC05-TB Manual - Página 4

Navegue en línea o descargue pdf Manual para Productos de fontanería Decor Star WPC05-TB. Decor Star WPC05-TB 5 páginas. Widespread two handles lavatory faucet

Imprimir página

Installation

A. Shut off water supply at the valves.

Remove old faucet and clean the

mounting surface for installation of new

faucet.

D. Apply Teflon (TPFE) tape on the

thread of the center spout brass pipe.

Use an adjustable wrench to tighten the

fittings. (NOTE: Do not overtighten the

connection.)

Hot

G. Apply Teflon (TPFE) plumbing tape

on both valve assemblies and shutoff

valves. Attach water supply hoses with

1/2" fittings (not included) with an ad-

justable wrench. Also connect the water

hose between the handle assemblies

and the center spout. (NOTE: Do not

overtighten the connection.)

Decor Star

B. Place spout with flange through the

center mounting hole on the mounting

surface.

E. Use a small hex wrench to loosen the

small setscrew on the handle. Lift up the

decorative trim handle and remove all

trim pieces.

Cold

H. Use the aerator wrench to remove

the aerator. Turn on both hot and cold

handles and let the water run for about

1 minute to flush out any sediment or

debris inside the plumbing. Also check

for leaks at all connections.

C. Insert the C shaped rubber / metal

washer and locking nut on the center

spout. Use an adjustable wrench to se-

cure spout in place. (NOTE: Do not over

tighten the locking nut.)

F. Insert hot and cold valves from under-

neath the mounting surface. Secure the

handle assemblies with the decorative

trims from top of the mounting surface.

I. Re-install the aerator once all con-

nections are checked. Keep the aerator

wrench for future use. The installation is

complete at this time.

WPC05 Rev. B 04/2018