GREEN POWERLINK R9P624NI00 Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Domótica GREEN POWERLINK R9P624NI00. GREEN POWERLINK R9P624NI00 17 páginas. On-line energy management solution
Imprimir páginaInstall Smart Power Strip
The smart power strip allows the user to track electricity consumption of group
home appliances in the same area and protect it against surge and voltage spikes.
1. Plug in the smart power strip to a powered AC outlet.
2. Plug in the appliances into the smart power strip outlets.
3. The Energy Saver outlets on the power strip can be manually turned ON/OFF
by pressing the "Manual ON/OFF" button on the power strip. You may also
control the energy saver outlets remotely by using the energy monitor (see
the operation instruction).
4. Perform initial energy monitor and smart power strip pair up (see the
operation instruction).
PROTECTED LED LIGHT
This LED light illuminates
to indicate that the surge
protection is active and
protecting equipments
from power surges.
GROUNDED LED LIGHT
This LED light illuminates
to indicate that the surge
protector is plugged into a
properly grounded outlet.
ALWAYS ON OUTLETS
are also available for
devices which are always
kept on and need
continuous power.
GREEN POWERLINK On-Line Energy Management Solution V1.0
Install CT Smart Meter in the circuit breaker panel
The CT smart meter allows the user to measure entire electricity
powerconsumption from electrical panel.
Your safety is very important to us. Please read these cautions
regarding the installation of your CT Smart Meter.
＊
when the main circuit breaker has been switched off. Do not attempt
any installation unless you are familiar where these electrified areas
are.
＊
electrical shock. It is highly recommended that all work should be
done only by qualified electricians or certified electrical specialist.
Prepare the electrical circuit breaker
Manual ON/OFF"
WARNING:
button
＊
breaker by turning off the main breaker or main switch.
＊
breaker or switch is turned off. Please indentify these wires and
components before installation and pay attention to these areas at all
time.
1. Turn off all power by turning off the main breaker or main switch.
2. Remove the cover of electricity circuit breaker panel.
6
!
Caution
Electrical panel contains live electrical wires and components even
Any work on or near electrical panel could induce danger or fatal
Before you start, you must turn off all power in the electrical circuit
Some wires and components could still be live even when the main
GREEN POWERLINK On-Line Energy Management Solution V1.0
7