Avantco CFD-2FF Manual del usuario - Página 4

Navegue en línea o descargue pdf Manual del usuario para Frigorífico Avantco CFD-2FF. Avantco CFD-2FF 6 páginas.

User Manual

Electrical

• Please ensure that the required voltage is being supplied at all times.

• The unit should be plugged into a grounded and properly-sized electrical outlet with appropriate

over-current protection. Please refer to the electrical requirements on the unit's nameplate.

• The unit should have its own dedicated outlet.

• Do not use extension cords.

• Ensure the unit is not resting on or against the electrical cord.

• If the unit is not in use for a long period of time, please unplug the unit from the outlet.

• To avoid shock and fire hazards, do not plug in or unplug the unit with wet hands.

• After unplugging the unit, wait at least 10 minutes before plugging it back in. Failure to do so could

cause damage to the compressor.

Temperature Controls

• Refrigerant LED - Compressor is on

• Fan LED - Fan is on

• Defrost LED - Defrost cycle is running

Functions

Set Temperature

Refrigerators are preset at the factory to run between 32 and 41 degrees Fahrenheit. Freezers are

preset at the factory to run between -7.5 and 0 degrees Fahrenheit. To manually adjust the unit's

running temperature, please follow the steps below.

1) Press SET button

2) Press UP or DOWN buttons to adjust

3) Press SET button to set

Manual Defrost

This unit is pre-programmed to run automatic defrost cycles at preset intervals. However, if you

would like to run a manual defrost cycle at any time, please follow the steps below.

Press and Hold DEFROST Button for 6 seconds to start or stop defrost cycle

NOTE: All other temperature control functions should only be used by an authorized service technician.

- 4 -