Decora Sunwood Instrucciones de montaje

Navegue en línea o descargue pdf Instrucciones de montaje para Persianas Decora Sunwood. Decora Sunwood 2 páginas. Basswood solid timber venetian blinds

Imprimir página

Sunwood 50mm Basswood- Solid Timber Venetian Blinds

MOUNTING HARDWARE

Mounting

Screw #1

Bracket

Screw #3

Valance Return

Clip

(Note: Centre support supplied for blind width 100cm or over)

TOOLS RECOMMENDED FOR INSTALLATION:

Metal tape

Pencil

Drill

measure

Children can be strangled in blind or drapery cords. To

keep cords out of reach of children, use these methods:

1. Clamp

2. Cleat

3. Tie the cord to itself

4. Tie-down device

WARNING

Young children can strangle in the loop of

pull cords, chains, tapes that operate window

coverings. They can also wrap the cords around

their necks. To avoid the risk of strangulation

and entanglement, keep cords out of the

reach of young children. Move beds, cots and

furniture away from window covering cords.

Valance Clip

Centre Support

Cord Cleat

Screw

Philips Head

Step

Screwdriver

Ladder

WARNING

Inside Mount

Screw #2

Mounting Bracket

Hold Down

Bracket

Headrail

Drill Bit

(1/8" diameter)

Valance

Return

Clip

Valance with Clip attached

Headrail

Tilt

Cord

child

safe

Bottom

rail

MOUNTING INSTRUCTIONS

A. Brackets should be placed at the

Outside Mount

width of blinds headrail 6mm past each

end. The bracket doesn't necessarily

Ceiling Mount

need to touch the inside face of the

window frame.

Screw #1

B. Align the top of the centre support

Centre Support

bracket with the top of the mounting

bracket before installation. Install with

the bigger flap of the centre support

bracket on the top side and clear of the

slat ladder positions.

Mounting Bracket

C. Push rail into brackets. Then press

Gate

gate to close brackets.

Mounting

Bracket

D. Screw valance clips onto back side

Valance Clip

of the valance with screws provided

(Screw #3)

Screw #3

E. For Outside Mount: Screw one

Valance

end of the valance return clip onto the

Screw #3

valance using Screw #3. Align the edge

of the valance return with the valance.

Screw the other end of the valance clip

onto the valance return.

Valance Return

F. Hook valance clip with valance

attached onto the top of the headrail.

Headrail

G. Always tilt blind horizontally before

raising/lowering to extend the life of

the blind. To lower blind: Move

cord to left pulling down gently until

Pull Cord

cord lock releases.To raise blind: Pull

cord downward until blind reaches

desired height. To lock cords: Pull

cord right and release. Cord will lock

automatically.

Installing Hold Down Brackets

(Optional)

H. Hold down brackets: Using two

small screws, screw hold down bracket

to window facing or wall.

Snap bracket pin ends into the hole at

Screw #2

bottom rail end.