KitchenAid KUDD01DPPA0 Manual de instrucciones de instalación - Página 3
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Lavavajillas KitchenAid KUDD01DPPA0. KitchenAid KUDD01DPPA0 16 páginas. Drawer dishwasher
Imprimir página
INSTALLATION REQUIREMENTS
Gather
the required
tools
and
parts
before
starting
instalhtion,
Read and follow
the instructions
provided
with
any tools
listed
here,
Tools needed:
[]
7 mm socket wrench
[]
utility knife
[]
5 mm socket wrench
[]
needle-nose pliers
[]
5 mm open end or box end
[]
tape measure
wrench
[]
flat-bladed screwdriver
[]
electric or hand drill
[]
#2 Phillips screwdriver
[]
1-1/2" hole saw
[]
side cutting pliers
[]
valve (sized to fit hot water
supply line) with 3/8" male
[]
pencil
compression fitting
[]
sandpaper
[]
protective floor covering
[]
level
[]
wood cutting board
[]
adjustable wrench that
opens to 1-1/8" (29 mm)
IMPORTANT: Observe all governing codes and ordinances.
Failure to meet codes and ordinances could lead to fire or
electrical shock.
Proper installation is your responsibility:
[]
Contact a qualified installer to ensure that the dishwasher is
installed to meet all electrical and plumbing national and local
codes and ordinances.
[]
Install the dishwasher as specified in these instructions.
[]
Have everything you need to properly install dishwasher.
[]
Protect dishwasher and water lines leading to dishwasher
against freezing. Damage from freezing is not covered by the
warranty.
[]
This dishwasher is manufactured for indoor use only.
[]
Install and level dishwasher on a floor that will hold the weight,
and in an area suitable for its size and use.
Product
dimensions
Parts supplied:
Located in bottom drawer:
[]
2 flexible trim pieces (for sides)
[]
1 flexible trim piece (for top)
[]
edge protection
[]
hose clamp, hose type
[]
washer
[]
2 installation brackets (top)
[]
drain hose support
[]
drain hose connector
[]
2 hose clamps, wire type
[]
24 #8 Phillips head wood screws
[] toe panel
[]
custom toe panel mounting bracket
[]
moisture protection tape
22-7/16" *
.__
23-7/18"
(57 cm)
raised tabs for
optional t op
attaching
brackets
\
_
20-15/32"
(52 cm)
_
drawer open
//1_
(59.5 cm)
32-3/16" -
34-1/2"
(81.8 cm -
87.8 cm)
side
attaching --S
tabs
2"- 4-3/8 ....
(5 cm - 11 cm)
* If custom wood panels are to be used, the product depth is specified with an
11/18'* (18 ram) door panel thickness.
** Toe panel depth: Factory supplied, 2-4-3/8"
(5 - 11 cm); Custom wood, 5**
(12.7 cm) less the toe panel thickness for integrated. Minimum panel thickness
using the supplied screws is 3/8'* (9 ram).
*** Door front height: Factory supplied - 30" (76.2 cm); Custom wood - 28-1/4'*
(71.8 cm) minimum.
NOTE: Product shown with front panels for dimension purposes.