KitchenAid KUDD01SSSS - 24" Single Drawer Dishwasher Manual de instrucciones de instalación - Página 8
Navegue en línea o descargue pdf Manual de instrucciones de instalación para Lavavajillas KitchenAid KUDD01SSSS - 24" Single Drawer Dishwasher. KitchenAid KUDD01SSSS - 24" Single Drawer Dishwasher 20 páginas. Single drawer dishwasher
Imprimir páginaOption 3: Air break connection
1. Route the drain hose as shown.
2. Decide if the drain hose needs to be trimmed. If it does,
trim it.
3. Slip a wire clip over the drain
hose. Push the hose into the
drain hose connector firmly, 5
clicks.
4. Position the wire clip between
the two positioning ribs on the
drain hose connector.
5. Attach the drain hose connector to the air break using the
supplied hose clamp.
air break
drain hose
connector
Connect to Water Supply
1. Install the flat seal washer on the end of the inlet hose.
Connect the inlet hose to the water supply valve. Tighten
securely.
2. Turn the water valve on and check for any leaks.
valve
3. Open the drawer. Remove the packing tape from the front and
rear of dish rack.
4. Close the drawer.
8
wire clip
drain hose connector
waste
valve
water supply
8" (20.3 cm) min. bend
radius from valve
flat seal
washer
inlet hose
Install Drawer Front Panel
Option 1: Install standard front panel
(on some models)
1. Remove front panel from box and discard all shipping
material.
2. Remove the tape securing the connector and wires from the
panel and the metal plate. Discard tape.
3. Connect the end of the medallion connector to the connector
from the drawer.
wire
opening
metal
plate
4. Gently feed the wires and connectors into the metal plate wire
opening.
5. Line up front panel tabs to slots in metal plate. Do not pull the
connector from the wire opening. Pull the drawer out slightly
to aid in installing the panel.
slots
6. Push the front panel down to lock in place.
7. When installed properly, the panel should be even with the top
of the dishwasher.
front panel
end of medallion
connector
front panel
tabs
metal plate