AFS AFS5001-1CTX Instrucciones de instalación y funcionamiento - Página 3
Navegue en línea o descargue pdf Instrucciones de instalación y funcionamiento para Transceptor AFS AFS5001-1CTX. AFS AFS5001-1CTX 15 páginas. Afs5001 series fiber optic video & data & ethernet transmission system 1-ch video bi-directional data 10/100 mbps ethernet transceiver
Imprimir página1-Ch. 8 BIT DIGITAL VIDEO + BI-DIRECTIONAL DATA + 10/100MBPS ETHERNET ON 1 FIBER
1.0 Safety Instructions
The safety information contained in this section, and on other pages of this manual,
must be observed whenever this unit is operated, serviced, or repaired. Failure to
comply with any precaution, warning, or instruction noted in the manual is in violation
of the standards of manufacture, warranty and intended use of the unit. ALBA assumes
no liability for the customer's failure to comply with any of these safety requirements.
DISCONNECTED OPTICAL CONNECTORS MAY EMIT OPTICAL ENERGY.
This product contains Class 1M lasers
• Class 1M laser product according to IEC60825-1:1993+A1+A2
• CAUTION: Use of controls or adjustments or procedures other than those specified
herein may result in hazardous radiation exposure.
• Precautions should be taken to prevent exposure to optical radiation if the internal PCB removed
from its enclosure or when the fiber is disconnected from the unit.
• Laser radiation may be present on a fiber connection to this unit even when the power has been
removed from the unit.
• This unit is intended for installation in locations where only trained service personnel have
access to the fiber connections.
• The optical connectors are listed in the Connection Diagrams and Function section of this
manual.
• Optical outputs and wavelengths are listed in the Specifications section of this manual.
The optical devices used in this equipment are Hazard Level 1M. As required by IEC60825-1, the
installer is responsible for insuring that the label depicted below is present in the restricted locations
where this equipment is installed.
This assembly contains parts sensitive to damage by electrostatic discharge (ESD).
Use ESD precaution procedures when touching, removing or inserting parts or
assemblies.
Units are not waterproof; please install in an appropriate NEMA Enclosure.
When units are installed in extremely hot environments, the metal enclosures
may become hot to the touch. Please install is restricted areas where properly
trained personnel have access.
Alba Fiber Systems Inc. Specifications are subject to change without notice. Page 3 9/27/12
www.albafiber.net
DO NOT VIEW BEAM WITH OPTICAL INSTRUMENTS (MAGNIFIERS).
LASER RADIATION CAUTION:
Series AFS5001