GREEN TECHNOLOGY GTS 1300 Manual - Página 6

Navegue en línea o descargue pdf Manual para Astilladora GREEN TECHNOLOGY GTS 1300. GREEN TECHNOLOGY GTS 1300 11 páginas. Woodchipper

2. Before operating the machine

M ake sure the machine stands firmly on the ground and does not

tilt in any way. The danger zone on the output of the machine must

be respected, in order to avoid serious injury by chips thrown out of

the output tube. Chips can be thrown a distance of 12 meters, so

onlookers must remain behind the direction of throw or at least 12

meters away from the output tube.

B efore using the machine for the first time, check the maximum

engine speed by screwing in/out the screw which controls the

position of the throttle lever so that it is positioned as in the

diagram.

A fter the first hour's use check that the bolts of the blades and

counter blade are firmly fixed and that the gap between blades and

counter blade is 0.5mm (half a millimetre). Use a torque wrench to

tighten the bolts; 70Nm for the blades on the rotor and 40Nm for the

counter blade. Adjust in the slots if necessary and fix the bolts with

Loctite 243.

Start the engine at half throttle and let it warm up for about 3

minutes. (For proper use of the engine one should also read the

attached manual of the HONDA GX390). Then put the engine on

full throttle. (fig. 9, 10)

Put the branches in the input tube and when you feel they are

pulled in by the rotating blades, let the branch go. Do not hang on

to the branch, the branch will be pulled in by the machine by itself.

Side branches with a diameter exceeding 3 cm should be sawn or

cut off and shredded separately.

Warning!

In case of emergency or any doubt, immediately activate the safety

switch (red knob) to be found by the engine. (fig. 11)

Before starting the engine check that the bolts holding the input and

output tubes are fully tightened. (fig. 12, 13)

Manual Chipper GTS 1300

fig. 9

fig. 11

fig. 12

fig. 13

Manual Chipper GTS 1300

fig. 10