BERNHARDT design a.k.a. Casegoods Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Mobiliario interior BERNHARDT design a.k.a. Casegoods. BERNHARDT design a.k.a. Casegoods 20 páginas.
![BERNHARDT design a.k.a. Casegoods Manual de instrucciones](/uploads/products/server2/2086175/2086175.jpg)
Step 7
Using a ¼" drill bit - drill through the pre-machined holes
on the Workwall Structure into the drywall. This will locate
the locations of the Snaptoggles®.
Note: you will also need to drill new holes through the
Workwall Structure along the line where you have
previously located the wall studs so that you can
connect the panel to the studs with a #8 or #10 screw.
Step 8
Once all the holes have been drilled, remove the temporary
drywall screws and set the first Workwall Structure section
aside. Using a ½" drill bit, open up all the ¼" holes just
drilled into the drywall to ½".
Step 9
Install 1 Toggler® Snaptoggle® wall anchor into each of
the ½" holes.
Step 10
The first Workwall Structure section can now be attached
to the wall using the ¼"-20 bolts into each of the Toggler®
wall anchors. Be sure to re-level before securing
the panel.
September 2012