BERNHARDT design a.k.a. Casegoods Manual de instrucciones - Página 8
Navegue en línea o descargue pdf Manual de instrucciones para Mobiliario interior BERNHARDT design a.k.a. Casegoods. BERNHARDT design a.k.a. Casegoods 20 páginas.
Imprimir página
Step 21
Slide the LED Light Rail into place, keeping the front edge
close to the underside of the shelf or overhead. The front
edge of the Light Rail Mount Brackets will catch the LED
Light Rail. Rotate the back edge up toward the underside
of the shelf or overhead and push upward until the
Mounting Brackets click. Pressure is best applied directly
underneath the Mounting Brackets.
Step 22
After the LED Light Rail is mounted, run the low voltage
power line behind the overhead unit and to the closest end
where it can be run down to the floor before the end caps
are installed.
To secure the power line behind the overhead, swing the
overhead out a little so you can loop the line over the
spacers on the back of the overhead.
Step 23
Identify the top Workwall Trim Cap. Place the Trim Cap on
the top of the Workwall Structure and line up the two ends
to the proper positions.
Using a rubber mallet, gently knock the extrusion in place.
The T-slot barb on the Trim Cap will fit into a groove along
the Workwall Structure.
September 2012