BERNHARDT design traction Instrucciones de instalación eléctrica - Página 7
Navegue en línea o descargue pdf Instrucciones de instalación eléctrica para Mobiliario interior BERNHARDT design traction. BERNHARDT design traction 8 páginas.
Imprimir página
Surface Mount Power Module and Connection
Traction offers a proprietary surface mount power solution allowing quick and easy "daisy chaining" of tables. For the surface mount
configurations up to (8) tables may be connected on a single power infeed. The surface mount power configuration uses a (2) receptacle /
(1) dual port USB module flush mounted in the center of the table. The power assembly and the Traction tables are UL 962 and CSA 22.2,
No. 203.2 approved. The illustration below is of a Traction starter table which must be specified to begin a run.
Installation Accessories
Surface Mount Power Module
A
Contains (2) 15 Amp receptacles and (2) amp USB port
for each power module.
Modular Connector
B
A modular connection to help the user connect multiple work
surfaces.
Power Module Control Unit
C
Control module with 10' grounded plug. Allows users to
connect up to 8 power/data centers off of one feed.
Power Module Wiring
D
A plug designed to be inserted into a receptacle in one
position only.
Wire Management Clip
E
Attaches to the bottom of the table, helps secure whips
when connected. Approved for GSA.
Connection Instructions
When starting to connect your power you first need to identify your starter table SKU (picture above is a starter table, found with a power module
control unit and grounded plug). Next you will want to gang your starter table with your first add-on table using the separately purchased ganging
brackets. To power the add-on table, pull the long modular connector wire from the starter table through the wire management clips. Locate the
module connector near the edge of the adjacent table trough. Match the keying, indicated by the arrows on the modular connects, and press the
connectors together. Repeat for all tables in line. 48"-60"w Tables: A maximum of (7) add-on tables are possible for a total of (8) daisy chained
tables. 66"-70"w Tables: A maximum of (3) add-on tables are possible for a total of (4) daisy chained tables.
Starter Table
Left Power Infeed
Leg Cover
Note: All power and wiring is pre-installed on starter and add-on
tables. Specify a right or left power infeed for the starter and add-on
table configurations.
Add-on Table
Left Power Add-On
After you have finished connecting the modular connectors, tuck them back into the
table trough, a concealed storage system, and move on to connecting your next table.
Cord Pass Flap
To connect two adjacent Traction tables with the modular
connectors from separate power units, you must lift the
cord pass flap first then pull the leg cover out of the leg
upright. This will give ample room for the large modular
connector to pass from the storage trough.
traction electrical installation instructions
surface mount power
5