Avantco 178AU48FHC Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Congelador Avantco 178AU48FHC. Avantco 178AU48FHC 10 páginas. Commercial refrigerators and freezers
También para Avantco 178AU48FHC: Manual del usuario (9 páginas)

Imprimir página

User Manual

Adjusting the temperature changes the minimum temperature your unit will run at. Your unit will not

run constantly at this setting. To change it, follow these instructions:

Digital Control Units

• Hold "SET" for 1 sec. The display will flash the current minimum temperature.

• Use the arrow buttons to adjust the minimum temperature you want it to run at.

• Press "SET" again to save your settings.

Always remember to calculate the differential if you change the minimum temperature setting.

The cabinet temperature will fluctuate up to +7 degrees over your set minimum temperature as

the compressor runs and shuts off. Setting the temperature too high will result in unsafe maximum

temperatures.

Freezer Control (phased out in 2022)

Refrigerator and Freezer Control (2022 onwards)

Prg

aux

mute

set

Set

def

Loading Product

Before loading shelves, please be sure that all shelf clips are completely fastened in their correct

locations. It is important that all shelves rest completely level before stocking your cabinet with

product. In order to maintain correct air flow inside the unit, please be sure to leave 2-4" of space

between the back wall and stored product. Blocking the evaporator fans will result in a warmer

cabinet temperature and ultimately compressor failure.

Running a Manual Defrost Cycle

This unit is pre-programmed to run automatic defrost cycles at preset intervals. However, if you

would like to run a manual defrost cycle at any time, please follow the steps below:

Freezers produced before 2022: Press the defrost button ("def" and down arrow) for approximately

5 seconds. Repeat to stop the defrost cycle.

Refrigerators and Freezers: Press the defrost button (snowflake symbol and down arrow) for

approximately 3 seconds. Repeat to stop the defrost cycle.