Makita 3707 Manual de instrucciones - Página 10

Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Makita 3707. Makita 3707 16 páginas. Trimmer
También para Makita 3707: Especificaciones (2 páginas), Manual de instrucciones (10 páginas), Manual de instrucciones (13 páginas)

Imprimir página

1. Adjusting screw

2. Clamp screw (B)

3. Trimmer guide

4. Clamp screw (A)

1. Workpiece

2. Bit

3. Guide roller

MAINTENANCE

1. Limit mark

Trimmer guide

001713

Trimming, curved cuts in veneers for furniture and the like can be done easily

with the trimmer guide. The guide roller rides the curve and assures a fine cut.

Install the trimmer guide on the tool base with the clamp screw (A). Loosen the

001714

clamp screw (B) and adjust the distance between the bit and the trimmer guide

by turning the adjusting screw (1 mm per turn). At the desired distance, tighten

the clamp screw (B) to secure the trimmer guide in place.

When cutting, move the tool with the guide roller riding the side of the work-

001998

piece.

CAUTION:

•

Always be sure that the tool is switched off and unplugged before

attempting to perform inspection or maintenance.

Replacing carbon brushes

001145

Remove and check the carbon brushes regularly. Replace when they wear

down to the limit mark. Keep the carbon brushes clean and free to slip in the

holders. Both carbon brushes should be replaced at the same time. Use only

identical carbon brushes.