CORNING LSE 6783 Manual de instrucciones - Página 6
Navegue en línea o descargue pdf Manual de instrucciones para Equipos de laboratorio CORNING LSE 6783. CORNING LSE 6783 9 páginas. Digital water bath
También para CORNING LSE 6783: Manual de instrucciones (8 páginas)
Imprimir página
11.0
OPERATION
Do not use this water bath in explosive or flammable environments. Do not
heat or incubate flammable, explosive, or highly reactive materials in this
water bath as serious injury may result.
Temperature of water bath cover and chamber edges may reach over 100°C.
Use protective gloves to avoid burns and injuries.
When opening the water bath cover, beware of steam. It may be very hot and
can cause burns on your face and hands.
Do not use tap water in water bath. You may only use distilled water!
Do not use the water bath without water. Minimum level of water is at least
50 mm.
1.
Place the unit on a level surface and plug the unit into a properly grounded outlet of
appropriate voltage.
2.
Fill the chamber with desired quantity of distilled water. Normal level of water is 2/3
of chamber height. Minimum level of water is at least 50 mm.
3.
Put the stainless steel cover on unit.
4.
Press the power switch to the ON position. The switch should illuminate. The water
bath automatically detects and displays the supply frequency as F50 or F60. Water
bath starts to heat.
5.
Set desired temperature with UP or DOWN key. You must hold UP or DOWN key
for more than 2 seconds. DOT on DISPLAY blinks. When DOT starts to blink (dot
blinks for 5 seconds), set temperature to desired value between room temperature
+5°C to 99°C. Two seconds after the desired temperature is set, the display will
automatically show momentary temperature.
6.
You can always look at set temperature by holding UP or DOWN key for more than
2 seconds.
4