CORNING LSE 6897-FB Manual de instrucciones - Página 5
Navegue en línea o descargue pdf Manual de instrucciones para Equipos de laboratorio CORNING LSE 6897-FB. CORNING LSE 6897-FB 12 páginas. Digital dry bath heater
Imprimir página
Caution: HOT surfaces that can burn or cause injury.
Use of this product in any manner not specified by the manufacturer or
modification of the product may cause injury and/or may void the warranty.
3.0 Installation
Upon unpacking the Corning® LSE™ Digital Dry Bath Heater, inspect for
damage. Shipping damage is the responsibility of the carrier. Inspect that
the following are present: instruction manual, data logger software, line
cord, block lifter, lid, USB cable.
Select a location that is dry and not subject to drafts or moving air from
heating or air conditioning vents or air blown by other equipment. Place
the unit on a flat, preferably non-flammable, surface. Allow sufficient room
around the unit for access and cooling (six inches minimum on all sides is
suggested). Plug the unit into a properly grounded outlet. Using the lifter,
insert the block(s) into the well. The unit is now ready for use.
4.0 Controls
On/Off rocker switch, located on the back of the unit: Turns primary power
on and off.
Start/Stop LED, red: Used to activate or stop the unit. Illuminates when unit
is in heating mode; off in temperature set mode.
Time LED, green: Used to set or select Time mode. This LED light indicates
running Time mode.
Heating LED, red: Illuminates when unit is in Heating mode and unit is
applying heat to the block. This LED is on continuously during heat-up and
cycles on and off when the unit is at the set temperature.
Temperature Up arrow key: Raises set temperature when unit is in Set mode.
Temperature Down arrow key: Lowers set temperature when unit is in Set mode
Timer Up arrow key: Raises set time when unit is in Set mode.
Timer Down arrow key: Lowers set time when unit is in Set mode.
3