Makita 4326 Manual de instrucciones - Página 10
Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Makita 4326. Makita 4326 13 páginas. Jig saw
También para Makita 4326: Especificaciones (2 páginas), Manual de instrucciones (13 páginas), Información técnica (7 páginas), Manual de instrucciones (13 páginas), Manual de instrucciones (13 páginas)
Imprimir página
Steel base type
1
008098
Aluminum base type
1
008099
When cutting circles or arcs of 170 mm or less in
radius, install the rip fence as follows.
Insert the rip fence into the rectangular hole on the
side of the base with the fence guide facing up.
Insert the circular guide pin through either of the
two holes on the fence guide. Screw the threaded
knob onto the pin to secure the pin.
Now slide the rip fence to the desired cutting radius,
and tighten the bolt to secure it in place. Then
move the base all the way forward.
NOTE:
Always use blades No. B-17, B-18, B-26 or B-27
•
when cutting circles or arcs.
Anti-splintering device for steel base
(optional accessory)
1
008100
For splinter-free cuts, the anti-splintering device can be
used. To install the anti-splintering device, move the
base all the way forward and insert it between the two
protrusions of the base.
1. Rip fence (Guide
rule)
1. Rip fence (Guide
rule)
1. Anti-splintering
device
2. Protrusions
2
NOTE:
The anti-splintering device cannot be used when
•
making bevel cuts.
Anti-splintering device for aluminum base
(Optional accessory)
1
008101
For splinter-free cuts, the anti-splintering device can be
used. To install the anti-splintering device, move the tool
base all the way forward and fit it from the back of tool
base. When you use the cover plate, install the
anti-splintering device onto the cover plate.
CAUTION:
The anti-splintering device cannot be used when
•
making bevel cuts.
Cover plate for aluminum base (Optional
accessory)
008102
Use the cover plate when cutting decorative veneers,
plastics, etc. It protects sensitive or delicate surfaces
from damage. Fit it on the back of the tool base.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
10
1. Anti-splintering
device
2. Aluminum base
2
1. Cover plate
1
2. Aluminum base
2