CORNING FBC-006 Funcionamiento - Página 4
Navegue en línea o descargue pdf Funcionamiento para Hardware de red CORNING FBC-006. CORNING FBC-006 4 páginas. Fiber cleaver
Imprimir página
Page 4
Blade Replacement
5.4 If your cleaver begins to perform inconsistently or fails
to make acceptable cuts, first clean the blade as described in
step 5.1 b.
Check the condition of the blade for damage — if nicks or
other damage to the blade are visible, replace the blade as
described in step 5.5.
5.5
To replace the diamond blade assembly (p/n
FBC-006-01):
a) Use a 2.5 mm hex key to remove the screws
from the blade access covers (Figure 9). Lift
the covers out of the cleaver base.
b)
Use a slotted screwdriver to remove the slotted
screw which serves as a blade retainer
(Figure 11).
c)
Use tweezers to remove the old blade assembly.
Retaining
screw
Blade
assembly
Blade
access
cover
Figure 11
d) Clean any dust or fiber fragments from inside
the base of the cleaver.
Special Note:
Fiber Optic
Training
Program
Corning Cable Systems offers comprehensive, integrated training
programs. Courses are structured for: Telephony, CATV, LAN,
Intelligent Transportation Systems and Power Utilities.
For information on Engineering Services Training call: 800-743-2671.
SRP-001-062
e) Insert the new blade assembly into the base of
the cleaver. Be sure to properly place its shafts
in the two recesses in the base of the cleaver.
f) Carefully replace the slotted retainer screw
removed in step b and the two covers and
cap screws removed in step a. Do not over
tighten the screws — the blade must be able to
pivot freely.
6. Technical Support
6.1 If the cleaver ever fails to work properly, you may:
• Talk to a Corning Cable Systems Engineer - call
800-743-2671, 8:30 am - 5:00 pm Eastern time.
and ask for the duty enginner.
• Return the cutter for service - contact your Corning
Cable Systems Customer Service Representative at
800-743-2671 or the numbers listed below
Corning Cable Systems reserves the right to improve, enhance, and modify
the features and specifications of Corning Cable Systems' products without
prior notification.
All trademarks are the property of their respective holders
Corning Cable Systems is ISO 9001 certified.
© 2008 Corning Cable Systems LLC.
Printed in U.S.A.
Corning Cable Systems
PO Box 489
Hickory, NC 28603-0489 USA
For US and Canada 1-800-901-2673
International
FAX: 828-901-5973
http:www.corning.com/cablesystems
All rights reserved.
828-901-5000
Issue 7