GarageAce S3 Manual del usuario - Página 6

Navegue en línea o descargue pdf Manual del usuario para Abrepuertas de garaje GarageAce S3. GarageAce S3 16 páginas.

Imprimir página
3.

Opener Installation

3.1. Important installation instructions

In order to reduce the risk of serious injuries or death, please read and follow all instructions
provided!
1)
Install only on a properly balanced door. An improperly balanced door has the potential
to inflict severe injury. Have a qualified service person make repairs to cables, spring
assemblies, and other hardware before installing the opener!
2)
Remove all ropes and remove or make inoperative all locks connected to the garage
door before installing opener!
3)
Where possible, install the operator 2.1 meters or more above the floor. Mount the
emergency release approx. 1.8 meters above the floor!
4)
Do not connect the opener to power source until instructed to do so!
5)
Locate the control button:
• Within sight of the door
• At a minimum height of 1.5 meters so small children are not able to reach it
• Away from all moving parts of the door
6)
Install the entrapment warning label next to the control button in a prominent location.
Use staple gun to secure label to surfaces to which the adhesive will not adhere. Install the
Emergency Release Marking. Attach the marking on or next to the emergency release!
7)
This motor is to be used only with residential sectional or one-piece tilt doors!
8)
To avoid damage to the garage door and operator, disable locks before installing and
operating the operator.
9)
Prior to installation check for and avoid any damaging of covered electrical, gas or water
lines in the walls or ceilings!
10) The garage ceiling must be designed so that a secure fastening of the operator is
guaranteed!
11) The installer must ensure that the motor is firmly attached to the garage structure! Do not
attach to gypsum or plaster ceilings!
12) The enclosed emergency release rope must be installed at an easy to reach height!
Check the emergency release to ensure operation with only moderate force required!
13) Do not use the emergency release rope to open or close the door!
14) Check the function of all safety devices (light beam device, emergency release, and
automatic reversal)!
15) After installing the opener, the door must reverse when it contacts a 40mm high object (or
a 50mm by 100mm board laid flat) on the floor!
16) The mechanical limitation device should be installed on the horizontal garage door's two
rails, in order to avoid the doors sliding out of the rail.
17) The installation and wiring must be complied with the architectural working standard and
electrical rules.
Work safely!
Always wear appropriate safety protection when using any tools!
For garages without a second access an additional emergency release is necessary, which
prevents a possible lock out!
2