CORNING PCH-96F-01U Manual - Página 7

Navegue en línea o descargue pdf Manual para Hardware de red CORNING PCH-96F-01U. CORNING PCH-96F-01U 9 páginas. Rack-mountable 1u 96-fiber housing

Step 4:

Route the connectorized fibers under the plastic tabs on the radius control guides.

Step 5:

Remove dust caps from the connectors and adapters into which they will be mated.

Refer to Section 5 for recommended cleaning procedures or clean the connector

end-faces and the adapter per standard company practices. Mate the connectors in

the adapters.

Step 6:

Use cable ties through the lances to secure fibers as needed.

4.6

Documentation

Record fiber identification information appropriately on the identification label (Figure 9). The

identification panel can be removed, if desired. Accurate recordkeeping is imperative for an

organized installation.

KPA-1006

4.7

Step 1:

Lift up on stop latches and slide drawer forward to make sure cable is not stressed.

If necessary, readjust cable strain-relief to prevent stress on fibers. Tighten UCC

clamp.

Step 2:

Slide drawer back to original position.

Step 3:

If previously removed, slide the cover back in the retaining flanges on top of the

housing. Push the plunger fasteners to secure.

Step 4:

Close the front and rear doors.

STANDARD RECOMMENDED PROCEDURE 003-723 | ISSUE 2 | OCTObER 2015 | PAGE 7 OF 9

KPA-0161

Figure 8

Figure 9