CORNING OSE-ST-2 Manual

Navegue en línea o descargue pdf Manual para Recinto CORNING OSE-ST-2. CORNING OSE-ST-2 8 páginas. Splice trays

OSE Splice Trays

P/N 001-285

Issue 4

related literature | Search www.corning.com/opcomm. Click on "Resources."

General

This document describes the installation of optical fiber with

both single fiber and/or ribbon fiber splices into Optical Splice

Enclosure (OSE) metal splice trays (Figure 1).

Make sure you read and understand this instruction as well

as instructions provided with related assemblies before

beginning an installation. This document should be used

in conjunction with instructions provided with the cables,

splicing components, and hardware being used.

Contact your Corning Customer Care representative for

assistance in purchasing items that are sold separately.

Precautions

2.1

Laser Handling Precautions

WARNING: Never look directly into the end of a fiber that may be carrying laser light. Laser light can

be invisible and can damage your eyes. Viewing it directly does not cause pain. The iris of the eye will

not close involuntarily as when viewing a bright light. Consequently, serious damage to the retina

of the eye is possible. Should accidental eye exposure to laser light be suspected, arrange for an eye

examination immediately.

WARNING: DO NOT use magnifiers in the presence of laser radiation. Diffused laser light can cause

eye damage if focused with optical instruments. Should accidental eye exposure to laser light be

suspected, arrange for an eye examination immediately.

2.2

Safety Precautions

CAUTION: Recommend the use of safety glasses (spectacles) conforming to ANSI Z87 for eye

protection from accidental injury when handling chemicals, cables, or working with fiber. Pieces of

glass fiber are very sharp and have the potential to damage the eye.

CAUTION: The wearing of cut-resistant safety gloves to protect your hands from accidental injury

when using sharp-bladed tools and armored cable is strongly recommended. Use extreme care when

working with severed armor. There will be a sharp edge where armor is cut. To minimize the chance

of injury from the cut armor, cover the exposed edge with a wrap of electrical tape. To minimize the

chance of injury from sharp-bladed tools, always cut away from yourself and others. Dispose of used

blades and armor scrap properly.

TPA-4955

Standard Recommended Procedure 001-285 | Issue 4 | February 2017 | Page 1 of 8

Figure 1