Makita 5026D Manual de instrucciones - Página 9

Navegue en línea o descargue pdf Manual de instrucciones para Herramienta eléctrica Makita 5026D. Makita 5026D 12 páginas. Makita cordless circular saws with dust collection
También para Makita 5026D: Información técnica (7 páginas)

Imprimir página

1. Specifications

1. Saw blade

2. Hex bolt

3. Outer flange

4. Inner flange

5. Cup washer

1. Hex wrench

OPERATION

1. Rear handle

2. Front grip

3. Base

To install the blade, follow the removal procedure in reverse. Install the cup

001447

washer, inner flange, saw blade, outer flange and hex bolt on the spindle in

that order. BE SURE TO TIGHTEN THE HEX BOLT CLOCKWISE

SECURELY.

After installing the blade, install the dust box and tighten the clamping screws

to secure the dust box.

When changing blade, make sure to also clean upper and lower blade guards

of accumulated sawdust. Such efforts do not, however, replace the need to

check lower guard operation before each use.

Hex wrench storage

001455

When not in use, store the hex wrench as shown in the figure to keep it from

being lost.

CAUTION:

•

Be sure to move the tool forward in a straight line gently. Forcing or

twisting the tool will result in overheating the motor and dangerous

kickback, possibly causing severe injury.

•

If the tool is operated continuously until the battery cartridge has

discharged, allow the tool to rest for 15 minutes before proceeding with a

fresh battery.

Hold the tool firmly. The tool is provided with both a front grip and rear handle.

001473

Use both to best grasp the tool. If both hands are holding saw, they cannot be

cut by the blade. Set the base on the workpiece to be cut without the blade

making any contact. Then turn the tool on and wait until the blade attains full

speed. Now simply move the tool forward over the workpiece surface, keeping

it flat and advancing smoothly until the sawing is completed.

To get clean cuts, keep your sawing line straight and your speed of advance

uniform. If the cut fails to properly follow your intended cut line, do not attempt

to turn or force the tool back to the cut line. Doing so may bind the blade and

lead to dangerous kickback and possible serious injury. Release switch, wait

for blade to stop and then withdraw tool. Realign tool on new cut line, and start

cut again. Attempt to avoid positioning which exposes operator to chips and

wood dust being ejected from saw. Use eye protection to help avoid injury.