Avante FURMDKAVNAH12 Manual del usuario - Página 5

Navegue en línea o descargue pdf Manual del usuario para Mobiliario interior Avante FURMDKAVNAH12. Avante FURMDKAVNAH12 12 páginas. Motorised height adjustable desk

Imprimir página

Motorised Height Adjustable Desk

Assembly

Take all parts out of the carton and place them on a firm, flat surface. Remove all packing materials and

check that all parts have been supplied and are in good condition.

Attach a desk foot (1) to the bottom of each leg assembly (2) using 4 M6 screws (3). The leg assemblies

are marked left and right ("right" being your right-hand side when standing at the desk) – the arrows on

the marking sticker should point toward the back and centre of the desk. When installing the feet, the

longer section should be facing toward the front of the desk (where you would be sitting / standing).

Firmly tighten the fasteners using the supplied Allen key.

Attach the motor module (4) to the rear of the leg assemblies using 8 M5 screws (5). Use the outer set

of 4 screw holes on either end of the motor module for attachment (this makes the distance between the

legs as wide as possible) and ensure to attach the motor module from the rear of the desk (opposite

where you would be sitting / standing). Firmly tighten the fasteners using the supplied Allen key.

Loosen the collars (B) on each drive link (6), then slide the hollow end of each drive link onto the motor

drive shaft (A). Push the drive link on fully, so the link and drive shaft have maximum engagement,

then rotate the collar right (clockwise) to secure the link to the drive shaft – do not over-tighten the

collar.

E&OE