CORNING EDGE8-02U Instalación y pruebas - Página 12

Navegue en línea o descargue pdf Instalación y pruebas para Unidad de control CORNING EDGE8-02U. CORNING EDGE8-02U 13 páginas. Tap module
También para CORNING EDGE8-02U: Instalación y pruebas (8 páginas)

Imprimir página

10. Simultaneous Testing of the Live and Tap Portions of an MTP

Tap Module

10.1

This section describes how to test the entire system at once with one source and two meters.

This is an alternative way to test compared to Steps 8 and 9. Note that this can only be done if all the

permanent harnesses are installed or test harnesses are purchased to mimic the harnesses that will be

installed. Also, three craft persons will be needed instead of two.

10.2

To calculate the system losses for the system use the values calculated above in Steps 8 and 9

and reference the test equipment as shown in Step 7.

10.3

To begin testing the system (Figure 16):

Step 1:

Install the Light Source/RJ1 LC connector into the number 2 port of the EDGE8

module, Module "B".

Step 2:

Install Meter 1/RJ2's LC connector adapter onto LC number 1 of the harness

plugged into the front-mounted LIVE Port of the MTP Tap module.

Step 3:

Install Meter 2/RJ3's LC connector adapter onto LC number 2 of the harness

plugged into the TAP port of the MTP Tap module.

Step 4:

Continue testing through on the even fibers of the EDGE8 module, Module "B," using

Tables 3 and 5 for testing sequences.

LC #1

"A"

RJ2

and

adapter

LC #8

Do NOT

disconnect

0.00 dB

LC #2

RJ3

and

LC #8

adapter

Do NOT

disconnect

0.00 dB

HPA-1006-EDGE8

STANDARD RECOMMENDED PROCEDURE 003-139-AEN | ISSUE 1 | JANUARy 2017 | PAGE 12 OF 13

Module harness

EDGE8 MTP Tap Module "A"

TAP port

test harness

"Near end"

Note: Fiber loss

depends on length

EDGE8 Module "B"

of system

multimode only

Do NOT

disconnect

RJ1

Light

Source

"Far end"

Figure 16