JAMEC PEM 58.302 Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Herramientas JAMEC PEM 58.302. JAMEC PEM 58.302 8 páginas. Air and water hose reel

DO NOT over tension the spring. doing

so will not allow the hose to be pulled out

entirely and may result in damage to the

hose reel and spring mechanism

CHANGING THE HOSE

1. Release all tension on the hose prior to

commencing. See section "ADJUSTING

THE SPRING TENSION".

2. Note that all the hose needs to be pulled

out from the hose reel prior to commencing.

So the procedure in point 1 will have to be

done several times as the spring tension

will increase as the hose is extracted.

3. Once all the hose has been

pulled out move to point 3.

NOTE: DO NOT attempt to change the

hose while any tension on the spring

exists. Doing so can cause injury.

4. Using a flat head screw driver, remove

the side cover marked "cover removal" by

prying it open where indicated. (this cover

is the same side as the inlet side of the

hose reel.

5. Move the internal drum until you expose

the hose connection window on the internal

drum. Use a small spanner / screw driver to

undo the hose clamp. Remove hose from

barded hose connection on the internal

drum and feed hose out of the hose reel.

6. Feed new hose through the roller guide

onto the barbed hose connection on the

internal drum. Retighten the hose clamp.

7. Replace the inlet side cover.

8. Re-tension the spring by following the

section "ADJUSTING THE SPRING

TENSION".

9. As the spring gets more tension the hose

will automatically retract back into the hose

reel. Once hose has completely retracted

into the hose reel, adjust the tension on the

spring accordingly.

DO NOT over tension the spring. Doing

so will not allow the hose to be pulled out

entirely and may result in damage to the

hose reel and spring mechanism.